4 Color Process Water Base Ink Complete Set

Four Color Process Water Base Ink

• Phthalate Free, Significantly large range of color
• Superior Quality Four Color Process Plastisol Ink
• More brilliant continuous tone image/outstanding color strength
• Performance makes it an ideal option for a variety of design and application

In Compliance with CPSIA(Consumer Product Safety Improvement Act) 2008 Section 101 Lead Content in substrates (<300 ppm lead) and Section 108 Phthalates (<.1 dbp dehp>

STOCK, END-USE:

Cotton, 50/50 cotton/polyester blends, and some synthetics.

DESCRIPTION:

Four Color Process Water Base Ink is formulated for excellent color reproduction and print quality in 4 color process halftone printing . These finely milled process colors permit the ink to pass through a fine mesh count without clogging during production, while maintaining excellent color strength with minimal deposit.
Note: Pre-test on actual substrate before any full production run, for adhesion, wash fastness and other desired effects.

FINISH:

Durable, soft-hand finish.

COLORS:

Permanent transparent colors.

SCREEN FABRIC:

Mesh counts up to 355 mono-filament polyester (142T European Mesh).

STENCIL:

Dual-sensitized direct method photo emulsion, that is water resistant.

SPECIAL INSTRUCTIONS:

When printing textiles, use a medium hard (70-85 durometer) squeegee.

STORAGE:

Water base respond to heat. Always store at cool room temperatures below 90°F (32°C). Avoid exposing leaving the lid off. Water base ink will dry out.

CURE/DRYING:

Heat-cure at approximately 320°F (160°C) for 2 to 3 minutes. Will not air-dry.

PACKAGING:

1- quart (0.945 Liter), 1-gallon (3.78 Liters), 5-gallon (18.9 Liters) containers. *30-gallon (113.4 Liters) and 55-gallon (207.9 Liters).

SAFETY & HANDLING:

Refer to Material Safety Date Sheet (MSDS) for complete information.